Control - Ecom CN Operating Instructions Manual

ECOM-P (Adjustment <F1> for Yes / <F4> for No):
- Adjusted of selected printer:
Eta(C) (<F1> for YES / <F4> for NO):
- Efficiency calculation with or without condensation gain

6. Control

The electrochemical sensors used for the gas analysis are submitted
to a wearing process and consequently do age. Along the operation
period, they alter their output values depending on the gas concen-
tration, flow duration and soiling degree of the measured gases. The
programme controls the sensors and corrects drifts. If drifts and the
correlated measurement errors increase, an error message is dis-
played. In this case the corresponding sensor must be changed by
an authorised service centre.
The control menu informs about the current status values for the
sensors and on 2 further pages (scroll display page via cursor key)
about:
- the battery voltage (charging state)
- the phone number of the next service centre
- the serial number
- the software version
- the operation hours
- the date of the last service
- the number of CO switch offs
- the number of errors occurred
ecom-CN
„YES" = ecom-P
„NO" = HP 82240B
O2 1034 mV
CO -10 mV
Batt 6.42 Volt
Tel.No. 02371/945-5
Ins.No. CN-0009
↑↓
Further info with
Oper. hours
Service date 23.06.04
CO switch offs
Error counter
Tel.No. 02371/945-5
Ins.No. CN-0009
Further info with ↑↓
Page 15
V1.1
!
7.39
0
00
V1.1
!