Data Processing Via Bluetooth (Option) - Ecom CN Operating Instructions Manual

Once the ecom-CN is identified, the message
„Connection build-up ..." and then „Start trans-
fer at ecom-CN" are displayed.
Press the „Print" key to start transferring the
data stored in the ecom-CN. Once the transfer
is completed, the measurement values are
displayed in a table on the PDA.
The user can then decide if he wants to keep
the values. By pressing the key „Cancel" the
measurement values get deleted and the pro-
gramme turns back in receiving mode.
Pressing the key „Accept" generates the data to be written in the file
ECOM.TXT and the programme is finished. The transfer between
PDA and instrument is secured via a check sum. In case of transfer
problems, the error message „Transfer error" is displayed.

7.3. Data processing via Bluetooth (option)

The following possibilities of data processing via Bluetooth are avail-
able:
1. Using the measurement data management programme
MiniDV
(gratis software from ecom GmbH).
Hereto the following adjustments must be made at the ecom-CN:
Adjustments-Internal-Baud rate->Bluetooth
and
Adjustments-Internal-Online data->none
2. Using the online data record programme DASNT
(gratis software from ecom GmbH).
Hereto the following adjustments must be made at the ecom-CN:
Adjustments-Internal-Baud rate->Bluetooth
and
Adjustments-Internal-Online data->DAS
Page 18 ecom-CN