Technical Data; Operating Environments; Explanation Of The Term "Duty Cycle - Fronius ActiveCharger 1000 Operating Instructions & Parts List Manual

Technical data

Operating envi-
ronments
Explanation of Duty cycle (D.C.) is the proportion of time in a 10-minute cycle at which the device may be
the term "duty cy- operated at its rated output without overheating.
cle"
Example: Welding at 150 A at 60% D.C.
-
-
-
If the device is to be continuously operated without stopping:
1
2
56
Transport, storage or operation of the charger outside the stipulated area will
be deemed improper. The manufacturer shall not be held liable for any dam-
age arising from such usage.
Ambient temperature range:
- during operation: -10 °C to +40 °C (14 °F to 104 °F)
- during transport and storage: -20 °C to +55 °C (-4 °F to 131 °F)
- recommended temperature range during charging: + 4 °C to + 40 °C (+
39,2 °F to + 104 °F)
Relative humidity:
- up to 50 % at 40 °C (104 °F)
- up to 90 % at 20 °C (68 °F)
The surrounding air must be free from dust, acids, corrosive gases or sub-
stances, etc.
Can be used at altitudes up to 2000 m (6561 ft.)
NOTE! The D.C. values specified on the rating plate are based on an ambient
temperature of 40°C. If the ambient temperature is higher, either the D.C. or out-
put must be reduced accordingly.
Welding phase = 60% of 10 minutes = 6 minutes
Cooling phase = remaining time = 4 minutes
After the cooling phase, the cycle begins anew.
150 A
0 A
0 Min.
look in the technical data for a D.C. value of 100% for the reigning ambient tempera-
ture.
Reduce the output or amperage in line with this value so that the device can remain in
use without observing a cooling phase.
60 %
6 Min.
6 Min.
4 Min.
10 Min.