Commissioning, Maintenance And Repair; Safety Symbols - Fronius ActiveCharger 1000 Operating Instructions & Parts List Manual

Commissioning,
maintenance and
repair

Safety symbols

20
A safety inspection should be carried out by a qualified electrician
- after any changes are made
- after any additional parts are installed, or after any conversions
- after repair, care and maintenance has been carried out
- at least every twelve months.
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspection and calibration can be obtained from your
service centre. They will provide you on request with any documents you may
require.
It is impossible to guarantee that bought-in parts are designed and manufac-
tured to meet the demands made of them, or that they satisfy safety require-
ments.
- Use only original spare and wearing parts (also applies to standard parts).
- Do not carry out any modifications, alterations, etc. to the device without
the manufacturer's consent.
- Components that are not in perfect condition must be replaced immedi-
ately.
- When ordering, please give the exact designation and part number as
shown in the spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing the
housing parts.
Only use original housing screws in the correct number and tightened to the
specified torque.
Devices with the CE mark satisfy the essential requirements of the low-voltage
and electromagnetic compatibility directive (e.g. relevant product standards
from the EN 60 974 series).
Fronius International GmbH declares that the device complies with directive
2014/53/EU. The full text of the EU Declaration of Conformity is available from
the following website: http://www.fronius.com
Devices with the CSA test mark satisfy the requirements of the relevant stand-
ards in Canada and the USA.