Tig Welding; General; Connecting The Gas Cylinder; Preparatory Work - Fronius ActiveCharger 1000 Operating Instructions & Parts List Manual

TIG welding

General

Connecting the
gas cylinder
1
1

Preparatory work

1
2
3
4
5
6
NOTE! Do not use pure tungsten electrodes (colour-coded green) if the TIG weld-
ing process has been selected.
WARNING! There is a high risk of very serious injury and damage if a gas cylin-
der falls over. Place gas cylinders on a solid, level surface so that they remain sta-
ble. Secure gas cylinders to prevent them from falling over.
Observe the safety rules of the gas cylinder manufacturer.
Press the On/Off button for at least two seconds to turn off the power source
- the indicators go out
Plug the TIG welding torch into the (-) current socket and turn it clockwise to latch it in
place
Set up the welding torch in accordance with the welding torch operating instructions
Plug the grounding cable into the (+) current socket and turn it clockwise to latch it in
place
Use the other end of the grounding cable to establish a connection to the workpiece
CAUTION! Risk of injury and damage from electric shock. As soon as the
power source is switched on, the electrode in the welding torch is live. Make
sure the electrode does not touch any persons or electrically conductive or
earthed parts (e.g. the housing, etc.).
Press the On/Off button for at least two seconds to turn on the power source
- the welding current indicator lights up
- the display shows the specified welding current
41