Fc And Fcoe Configuration Example By Using Fc Interfaces And Vfc Interfaces (In Standalone Mode); Network Requirements - HP 5920 SERIES Fc And Fcoe Configuration Manual

Verifying the configuration on Switch D
Verify the configuration Switch D in the same way you verify the configuration on Switch C.
FC and FCoE configuration example by using FC
interfaces and VFC interfaces (in standalone mode)

Network requirements

As shown in
Switch A and Switch B are connected to an Ethernet switch, and operate at the access layer of the
•
LAN.
• Switch A and Switch B are connected to Switch C and Switch D, respectively.
The four switches operate as the FCF switches of the SANs.
•
Configure FC and FCoE to meet the following requirements:
The transmission network formed by Switch A, Switch B, and the Ethernet switch can use the server
•
to provide services for the LAN. The transmission network formed by switches A through D can
enable the server to access the disk device.
Link backup is used to implement high availability for the packets to and from the server and disk
•
device.
• The bandwidth is increased for the link between Switch A and Switch C and the link between Switch
B and Switch D, and link backup and load sharing are implemented.
Figure 49:
198