Rscn Aggregation; Configuration Procedure; Configuring And Obtaining Fc4 Information Of Nodes - HP 5920 SERIES Fc And Fcoe Configuration Manual

When a change occurs, the switch sends ELS_RSCNs to its concerned registered nodes and SW-RSCNs
to all reachable switches in the fabric. After receiving an RSCN, a switch or node automatically sends a
name service query to obtain the new information. The switch receiving an RSCN also sends ELS_RSCNs
to notify their concerned registered nodes. As a result, the changed information is notified and updated
throughout the fabric.
NOTE:
Support for SW-RSCNs depends on the ESS negotiation between switches.
•
Concerned registered nodes refer to the nodes that have sent SCR requests to the switch for receiving
•
RSCNs. Only these registered nodes can receive and respond to ELS_RSCNs.

RSCN aggregation

If changes occur on multiple nodes at the same time, the switch quickly sends multiple ELS_RSCNs for
each change to the concerned registered nodes. This can cause a sharp decline in transmission and
processing performance.
RSCN aggregation can alleviate the problem by using an RSCN aggregation timer. If multiple changes
occur within the RSCN aggregation timer, the switch sends the FC addresses of the nodes with changes
in one RSCN.

Configuration procedure

HP recommends that you enable RSCN aggregation and set the same timer value on all switches in a
VSAN. The RSCN aggregation timer takes effect only when RSCN aggregation is enabled.
To configure RSCN aggregation:
Step
1. Enter system view.
2. Enter VSAN view.
3. Enable RSCN aggregation.
4. Set the RSCN aggregation
timer.
Configuring and obtaining FC4 information of
nodes
After a node registers with a switch through a FLOGI, the node sends a name service registration request
to the switch to register extended information, including FC4 information.
Command
system-view
vsan vsan-id
rscn aggregation enable
rscn aggregation timer time
60
Remarks
N/A
N/A
By default, RSCN aggregation is
disabled.
The default setting is 2000
milliseconds.
You can adjust this timer to control the
frequency the switch responds to node
information changes based on switch
performance.