Requirements Analysis; Configuration Procedure - HP 5920 SERIES Fc And Fcoe Configuration Manual

Requirements analysis

To meet the network requirements, divide VSAN 1 into three zones as follows:
• Assign Server A to Zone 1.
Assign Server B and Disks A, B, and C to Zone 2.
•
Assign Server C and Disks B and C to Zone 3.
•
Enable Pairwise for Zone 2, configure Server B as an initiator, and configure Disks A, B, and C as
•
targets.
Enable Pairwise for Zone 3, configure Server C as an initiator, and configure Disks B and C as
•
targets.
• Create zone alias Alias 1, which contains Disks B and C, to simplify the configuration.
Create zone set Zoneset 1, which contains Zones 1, 2, and 3, and activate it.
•

Configuration procedure

This section describes only FC zone configurations on Switch A. You do not need to configure FC zones
on Switch B.
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
<SwitchA> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
# Enable the enhanced zoning mode in VSAN 1.
[SwitchA] vsan 1
[SwitchA-vsan1] zone mode enhanced
116