Displaying And Maintaining Fc Interfaces - HP 5920 SERIES Fc And Fcoe Configuration Manual

Step
5. (Optional.) Configure a
description for the FC
interface.
6. (Optional.) Configure the
BB_Credit value for the
FC interface.
7. (Optional.) Configure the
fill word mode for the FC
interface.
8. (Optional.) Configure the
expected bandwidth of
the interface.
9. (Optional.) Restore the
default settings for the FC
interface.
10. Bring up the FC
interface.

Displaying and maintaining FC interfaces

Execute display commands in any view and reset commands in user view.
Task
Display FC interface information.
Clear statistics for FC interfaces.
Command
description text
fcb2bcredit credit-value
fill-word { idle-arbff |
idle-idle }
bandwidth
bandwidth-value
default
undo shutdown
Command
display interface [ fc ] [ brief [ down ] ]
display interface [ fc [ interface-number ] ] [ brief [ description ] ]
reset counters interface [ fc [ interface-number ] ]
16
Remarks
By default, the description of an FC interface is
in the format interface name Interface, for
example, Fc1/0/1 Interface.
The default setting is 15.
By default, the fill word mode is idle-arbff for an
FC interface operating at 8 Gbps.
This command is available on only FC
interfaces operating at 8 Gbps. This command
does not take effect on FC interface operating
at 2 Gbps or 4 Gbps, and these FC interfaces
supports only the fill word mode idle-idle.
To make the fill word mode configuration take
effect, you must re-enable the FC interface by
using the shutdown command and then the
undo shutdown command.
By default, the expected bandwidth (in kbps) is
the interface baud rate divided by 1000.
N/A
By default, an FC interface is up.