Task
Display FC FIB table information.
Display FC Exchange table information.
Display FSPF neighbor information.
Display link state database information.
Display FSPF GR state information.
Display FSPF statistics.
Clear FSPF statistics.
FC routing configuration examples
Static FC routing configuration example by using FC interfaces
Network requirements
As shown in
other.
Figure 27 Network diagram
FC1/0/1
XGE1/0/1
Switch A
Domain ID: 1
Configuration procedure
This section describes only FC routing configurations.
1.
Configure Switch A:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
Figure
27, configure static routes to enable any two FC switches to communicate with each
Switch B
Domain ID: 2
FC1/0/1
FC1/0/2
XGE1/0/1
XGE1/0/2
XGE1/0/2
Command
display fc fib [ fcid [ mask-length ] ] vsan vsan-id
display fc exchange { link | protocol } [ slot slot-number ]
display fc exchange link verbose [ slot slot-number [ exid
exid ] ]
display fspf neighbor [ vsan vsan-id ]
display fspf lsdb [ vsan vsan-id ]
display fspf graceful-restart [ vsan vsan-id ]
display fspf statistics [ vsan vsan-id ]
reset fspf counters [ vsan vsan-id ]
FC1/0/2
Switch C
Domain ID: 3
79