Configuring The Default Zone Policy; Configuring The Zone Distribution And Merge Type; Configuring A Merge Control Mode - HP 5920 SERIES Fc And Fcoe Configuration Manual

Configuring the default zone policy

In enhanced zoning mode, the switch distributes the default zone policy with other zone data. In basic
zoning mode, you must manually configure a consistent default zone policy across the fabric.
When the switch performs a zoning mode switchover, it also distributes the default zone policy with other
zone data.
To configure the default zone policy:
Step
1. Enter system view.
2. Enter VSAN view.
3. Permit members in the
default zone to access
each other.
4. Deny members in the
default zone from
accessing each other.

Configuring the zone distribution and merge type

Complete distribution (or merge) distributes (or merges) both the active zone set and zone database.
Incomplete distribution (or merge) distributes (or merges) only the active zone set.
This feature is supported only in basic zoning mode. In enhanced zoning mode, the zone distribution
and merge type is always complete, and this feature is not supported.
The configured distribution type applies to distribution operations triggered by the zoneset activate
command instead of the zoneset distribute command.
The configured merge type applies to all merge operations.
To configure the zone distribution and merge type:
Step
1. Enter system view.
2. Enter VSAN view.
3. Configure the zone
distribution and merge
type as complete.

Configuring a merge control mode

Two merge control modes are available: Restrict and Allow. For information about these two modes, see
"Zone merge in enhanced zoning
Command
system-view
vsan vsan-id
zone default-zone permit
undo zone default-zone permit
Command
system-view
vsan vsan-id
zoneset distribute full
mode."
110
Remarks
N/A
N/A
Use one of the commands.
By default, default zone members
are not permitted to access each
other.
Remarks
N/A
N/A
The default setting is incomplete.