HP 5920 SERIES Fc And Fcoe Configuration Manual page 52

[SwitchA] quit
# Reboot the switch.
<SwitchA> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
# Create VSAN 10 and VSAN 20.
[SwitchA] vsan 10
[SwitchA-vsan10] quit
[SwitchA] vsan 20
[SwitchA-vsan20] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/1 into FC interface FC 1/0/1.
[SwitchA] interface ten-gigabitethernet 1/0/1
[SwitchA-Ten-GigabitEthernet1/0/1] port-type fc
# Configure the mode of interface FC 1/0/1 as F.
[SwitchA-Fc1/0/1] fc mode f
# Configure interface FC 1/0/1 to autonegotiate the speed.
[SwitchA-Fc1/0/1] speed auto
# Assign FC interface FC 1/0/1 to VSAN 10 as an access port.
[SwitchA-Fc1/0/1] port access vsan 10
[SwitchA-Fc1/0/1] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/2 into FC interface FC 1/0/2.
[SwitchA] interface ten-gigabitethernet 1/0/2
[SwitchA-Ten-GigabitEthernet1/0/2] port-type fc
# Configure the mode of interface FC 1/0/2 as F.
[SwitchA-Fc1/0/2] fc mode f
# Configure interface FC 1/0/2 to autonegotiate the speed.
[SwitchA-Fc1/0/2] speed auto
# Assign FC interface FC 1/0/2 to VSAN 20 as an access port.
[SwitchA-Fc1/0/2] port access vsan 20
[SwitchA-Fc1/0/2] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/4 into FC interface FC 1/0/4.
[SwitchA] interface ten-gigabitethernet 1/0/4
[SwitchA-Ten-GigabitEthernet1/0/4] port-type fc
# Configure the mode of interface FC 1/0/4 as E.
[SwitchA-Fc1/0/4] fc mode e
# Configure interface FC 1/0/4 to autonegotiate the speed.
[SwitchA-Fc1/0/4] speed auto
# Configure the trunk mode of interface FC 1/0/4 as On, and assign interface FC 1/0/4 to
VSANs 10 and 20 as a trunk port.
[SwitchA-Fc1/0/4] port trunk mode on
45