Task
Display global FCoE configuration.
FCoE enabling configuration example
Network requirements
As shown in
of devices, network adapters, and cables.
Figure 18 Network diagram
Configuration procedure
Configure the FCF switch as follows:
1.
Enable the advanced mode:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
<Sysname> system-view
[Sysname] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[Sysname] quit
Figure
18, use FCoE in a data center combining a LAN and a SAN to reduce the number
Command
display fcoe
32