Creating A Vsan; Configuring The Trunk Mode - HP 5920 SERIES Fc And Fcoe Configuration Manual

Figure 21 VSAN trunk
FC switch A
VSAN 1
VSAN 2
VSAN 3
VSAN 4

Creating a VSAN

By default, only the default VSAN (VSAN 1) exists. You cannot create or delete VSAN 1. You can create
VSANs 2 to 3839.
The maximum number of VSANs (including VSAN 1) allowed on a switch is 16.
To create a VSAN:
Step
1. Enter system view.
2. Create a VSAN and enter VSAN view.

Configuring the trunk mode

The trunk mode configuration is available only on FC interfaces and FC aggregate interfaces. VFC
interfaces can work only as trunk ports, so you do not need to configure the trunk mode for VFC
interfaces.
To configure the trunk mode:
Step
1. Enter system view.
2. Enter FC interface view or
FC aggregate interface
view.
FC switch B
VSAN 1
VSAN 2
VSAN 3
FC switch C
VSAN 1
VSAN 2
VSAN 4
Command
system-view
vsan vsan-id
Command
system-view
interface { fc | san-aggregation }
interface-number
41
Remarks
N/A
By default, only VSAN 1 exists.
Remarks
N/A
N/A