Programming; Programming With The Local Control Panel (Lcp) - Danfoss VLT HVAC Basic Drive FC 101 Quick Manual

Quick Guide
1 1

1.4 Programming

1.4.1 Programming with the Local Control
Panel (LCP)
NOTE!
The adjustable frequency drive can also be programmed
from a PC via RS-485 COM port by installing the MCT 10
Set-up Software. This software can either be ordered using
code number 130B1000 or downloaded from the Danfoss
website: www.danfoss.com/BusinessAreas/DrivesSolutions/
softwaredownload
1.4.2 Local Control Panel (LCP)
The following instructions are valid for the FC 101 LCP. The
LCP is divided into four functional sections.
A. Alphanumeric display
B. Menu key
C. Navigation keys and LEDs
D. Operation keys and LEDs
1
2
3
4
6
10
7
8
9
Figure 1.27
A. Alpha Numeric Display
The LCD display is backlit with two alpha-numeric lines. All
data is displayed on the LCP.
1-20
1-20 Motor Power
A [5] 0.37kW - 0.5HP
Setup 1
Main
Status Quick
B Menu
Menu
Menu
Com.
C
On
OK
Warn.
Alarm
Hand O Auto
D
On Reset
13 14
MG18A422 - VLT
®
VLT HVAC Basic Drive Quick Guide
Information can be read from the display.
1 Parameter number and name.
2 Parameter value.
3 Set-up number shows the active set-up and the edit set-
up. If the same set-up acts as both the active and edit set-
up, only that set-up number is shown (factory setting).
When the active and edit set-up differ, both numbers are
shown in the display (Set-up 12). The flashing number
indicates the edit set-up.
4 Motor direction is shown to the bottom left of the display
– indicated by a small arrow pointing either clockwise or
counter-clockwise.
5 The triangle indicates if the LCP is in status, quick menu or
main menu.
Table 1.23
B. Menu key
Use the menu key to select between status, quick menu or
main menu.
C. Navigation keys and LEDs
6 COM LED: Flashes when bus communication is communi-
cating.
7 Green LED/On: Control section is working.
8 Yellow LED/Warn.: Indicates a warning.
9 Flashing Red LED/Alarm: Indicates an alarm.
10 [Back]: For moving to the previous step or layer in the
navigation structure
5
▲
11 [
] [
parameters and within parameters. Can also be used for
setting local reference.
12 [OK]: For selecting a parameter and for accepting changes to
11
parameter settings
12
Table 1.24
11
11
D. Operation keys and LEDs
13 [Hand On]: Starts the motor and enables control of the
On
adjustable frequency drive via the LCP.
NOTE!
Terminal 27 Digital Input (5-12 Terminal 27 Digital
15 Input) has coast inverse as default setting. This means
that [Hand On] not starts the motor if there is no 24
V to terminal 27. Connect terminal 12 to terminal 27.
14 [Off/Reset]: Stops the motor (Off). If in alarm mode the
alarm will be reset.
15 [Auto On]: The adjustable frequency drive is controlled
either via control terminals or serial communication.
Table 1.25
®
is a registered Danfoss trademark
▼
] [►]: For navigating between parameter groups,