Quick Connect Wiring - Emerson Rosemount 3051S Series Reference Manual

Rosemount 3051S Series

Quick Connect Wiring

Figure 2-11. Rosemount 3051S
Quick Connect Exploded View
Figure 2-12. Quick Connect
Housing Pin-Out
2-20
As standard, the 3051S Quick Connect arrives properly assembled to the
SuperModule and is ready for installation. Cordsets and Field Wireable
Connectors (in shaded area) are sold separately.
Straight Field
Wireable
(1)(3)
Connector
Quick Connect Housing
IMPORTANT
If Quick Connect is ordered as a 300S spare housing or is removed from the
SuperModule, follow the instructions below for proper assembly prior to field
wiring.
1. Place the Quick Connect onto the SuperModule. To ensure proper pin
alignment, remove coupling nut prior to installing quick connect onto
SuperModule.
2. Place coupling nut over quick connect and wrench tighten to a maximum
of 300 in-lb. (34 N-m).
3. Tighten the set screw using a
4. Install Cordset/ Field Wireable Connectors onto the Quick Connect.
Do not over tighten.
For other wiring details, refer
to pin-out drawing and the
cordset manufacturer's
installation instructions.
Reference Manual
00809-0100-4801, Rev FA
Right Angle Field Wireable Connector
Cordset
Cordset / Field Wireable Coupling Nut
Quick Connect Coupling Nut
(1) Order part number 03151-9063-0001.
(2) Order part number 03151-9063-0002.
(3) Field wiring supplied by customer.
(4) Supplied by cordset vendor.
/ -in hex wrench.
3
32
Ground
October 2010
(2)(3)
(4)
"+"
"–"
No Connection