User Interface - Emerson Rosemount 3051S Series Reference Manual

Reference Manual
00809-0100-4801, Rev FA
October 2010

USER INTERFACE

Figure 7-1. Device Dashboard
Diagnostic Action
Settings
The 3051S with Advanced HART Diagnostic Suite can be used with any asset
management software that supports Electronic Device Description Language
(EDDL) or FDT/DTM.
Advanced HART Diagnostics is best viewed and configured using the latest
Device Dashboard interface based on Human Centered Design concepts.
The Device Dashboard can be obtained with DD revision 3051S HDT Dev. 3
Rev. 1.
The following screen shots are taken from Emerson Process Management's
AMS™ Device Manager, version 10.5. All screens shown are based on the
Device Dashboard interface.
Figure 7-1 is the landing screen for the 3051S with Advanced HART
Diagnostic Suite. The device status will change if any device alerts are active.
Graphical gauges provide quick reading of the primary purpose variables.
Shortcut buttons are available for the most common tasks.
Each diagnostic allows the user to select a type of action to take if the
diagnostic is tripped.
None – Transmitter provides no indication that any trip values were exceeded
or the diagnostic is turned off.
Alert Unlatched – Transmitter generates digital HART alert and does not
affect the 4 – 20 mA signal. When conditions return to normal or within
threshold levels, the alert is automatically cleared.
Alert Latched – Transmitter generates digital HART alert and does not affect
the 4 – 20 mA signal. When conditions return to normal, an alert reset is
required to clear the status. This type of alert action is recommended if a 3rd
party alert monitor software is likely to miss alerts due to slow polling of HART
data.
Alarm – Transmitter drives mA output to the configured Failure Alarm level
(HIGH or LOW).
Rosemount 3051S Series
7-3