Mount The Transmitter - Emerson Rosemount 3051S Series Reference Manual

Rosemount 3051S Series
Figure 2-2. Cover Jam Screw

Mount the Transmitter

2-6
®
PlantWeb Housing
Mounting Brackets
Facilitate mounting transmitter to a 2-in. pipe, or to a panel. The B4 Bracket
(SST) option is standard for use with the Coplanar and In-Line process
connections. "Coplanar Flange Mounting Configurations" on page A-18
shows bracket dimensions and mounting configurations for the B4 option.
Options B1–B3 and B7–B9 are sturdy, epoxy/polyester-painted brackets
designed for use with the traditional flange. The B1–B3 brackets have carbon
steel bolts, while the B7–B9 brackets have stainless steel bolts. The BA and
BC brackets and bolts are stainless steel. The B1/B7/BA and B3/B9/BC style
brackets support 2-inch pipe-mount installations, and the B2/B8 style brackets
support panel mounting.
NOTE
Verify transmitter zero point after installation. To reset zero point, refer to
"Sensor Trim Overview" on page 4-5.
Flange Bolts
The 3051S can be shipped with a Coplanar flange or a Traditional flange
installed with four 1.75-inch flange bolts. Mounting bolts and bolting
configurations for the Coplanar and Traditional flanges can be found on
page 2-8. Stainless steel bolts supplied by Emerson Process Management
are coated with a lubricant to ease installation. Carbon steel bolts do not
require lubrication. No additional lubricant should be applied when installing
either type of bolt. Bolts supplied by Emerson Process Management are
identified by their head markings:
Carbon Steel (CS) Head Markings
B7M
B8M
316
Alloy K-500 Head Marking
KM
Junction Box Housing
Cover Jam
Screw
2X Cover Jam Screw
(1 per side)
Stainless Steel (SST) Head Markings
660
F593_* F593_* * The last digit in the F593_ head marking
CL A
may be any letter between A and M.
Reference Manual
00809-0100-4801, Rev FA
October 2010