12
SERVICE WORK ON THE CHASSIS
12.10
Removing the seat
12.11
Mounting the seat
–
Remove the motorcycle from the work stand.
–
Pull on the loop
–
Pull off the seat sideways at the front ends from the side cover.
–
Pull seat back and lift it off.
V00492-10
–
Stretch the seat at the front ends slightly and position holding tabs
The holding tabs engage in the holder.
–
Press holding tab
–
Insert locking pin
until the locking pin engages with an audible click.
–
Check, finally, that the seat is correctly mounted.
V00497-10
while raising the rear of the seat.
into the bushings
.
into the lock housing
on holders
and push down the rear of the seat
85
.