Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.20
Removing the seat
–
Position the rear frame.
–
Mount and tighten screws
Guideline
Screw, subframe
–
Remove screws
–
Mount and tighten screws
Guideline
Screw, subframe
M00297-11
–
Position the manifold.
–
Attach springs
Spring hooks (50305017000)
–
Mount and tighten screw
Guideline
Screw, manifold holder
M00300-11
–
Position the angle lever and linkage lever.
–
Mount and tighten screw cap
Guideline
Nut, linkage lever to angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
M00301-10
Finishing work
–
Install the main silencer. (
–
Install the right side cover. (
–
Mount the seat. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Lift up the seat at the rear, pull it back and then remove it from above.
M00259-10
on both sides.
M8
on both sides.
on both sides.
M8
.
.
.
.
M10
p. 45)
p. 46)
p. 43)
in the recessed grips on the left and right.
30 Nm
Loctite
(22.1 lbf ft)
Loctite
30 Nm
(22.1 lbf ft)
M8
15 Nm (11.1 lbf ft)
M14x1.5
80 Nm (59 lbf ft)
60 Nm
Loctite
(44.3 lbf ft)
p. 33)
42
®
2701™
2701™
®
®
2701™
Advertisement
Table of Contents
