Husqvarna 701 Supermoto 2017 Owner's Manual page 98

12 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding guard:
–
Replace the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard
F00597-10
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on an old, worn rear sprocket or engine
sprocket.
M6
Loctite ® 243™
8 Nm
(5.9 lbf ft)
96