13
BRAKE SYSTEM
13.8
Adjusting the basic position of the foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
Loosen fittings
–
To adjust the basic position of the foot brake lever to individual requirements, loosen
nut
and turn screw
Info
The range of adjustment is limited. The screw must be screwed into the
footrest bracket by at least four turns.
–
Position foot brake cylinder
travel.
–
Tighten fittings
Guideline
Screw connection, foot brake cylinder
–
Check the free travel of the foot brake lever. (
–
Tighten nut
F00629-10
on foot brake cylinder
accordingly.
so that the foot brake lever has the necessary free
.
.
.
M6
10 Nm (7.4 lbf ft)
p. 110)
111