Configuring The Virtual Servers - TP-Link TL-R470T Plus Configuration Manual

Configuring Transmission
Description
Status
2) Click OK.
Note:
One-to-One NAT take effects only when the connection type of WAN is Static IP.

2.3 Configuring the Virtual Servers

Choose the menu Transmission > NAT > Virtual Servers and click Add to load the
following page.
Figure 2-3 Configuring the Virtual Servers
Follow these steps to configure the Virtual Servers:
1) Specify the name of the Virtual Server rule and configure other related parameters.
Interface
External Port
Internal Port
Internal Server
IP
Protocol
Status
2) Click OK.
Give a description for the rule entry to facilitate your management.
Check the box to enable the rule.
Specify the effective interface for the rule.
Enter the service port or port range the router provided for accessing external
network. The ports or port ranges cannot overlap with those of other virtual
server rules.
Specify the service port or port range of the LAN host as virtual server.
Enter the IP address of the specified internal server for the entry. All the requests
from the internet to the specified LAN port will be redirected to this host.
Specify the protocol used for the entry.
Check the box to enable the rule.
NAT Configurations
Configuration Guide 60