TP-Link TL-R470T Plus Configuration Manual page 18

Table of Contents

Advertisement

Configuring Network
MTU
Primary/
Secondary DNS
VLAN
Get IP using
Unicast DHCP
Connect/
Disconnect
 Configuring the Static IP
Choose the menu Network > WAN > WAN to load the following page.
Figure 2-3 Configuring the Static IP
In Connection Configuration section, select the connection type as Static IP. Enter the
corresponding parameters and click Save.
Specify the MTU (Maximum Transmission Unit) of the WAN port.
MTU is the maximum data unit transmitted in the physical network. When Dynamic
IP is selected, MTU can be set in the range of 576-1500 bytes. The default value is
1500.
Optional. Enter the IP address of the DNS server provided by your ISP.
Add the WAN port to a VLAN. Generally, you don't need to manually configure it
unless required by your ISP.
By default, the WAN port is automatically assigned to a VLAN, and the egress rule of
the VLAN is UNTAG, so the packets are transmitted by the WAN port without VLAN
tags. If you want the WAN port to transmit packets with VLAN tag, you need to create
the corresponding VLAN first and configure its egress rule as TAG, then manually
add the WAN port to that VLAN. To create VLANs, go to Network > VLAN > VLAN.
Note: When using the IPTV function, either in Bridge mode or Custom mode,
the router will automatically create corresponding VLANs after you finished the
configuration, and add port 1 (WAN 1) to the VLANs. Users cannot then manually
select the VLAN that WAN 1 belongs to.
The broadcasting requirement may not be supported by a few ISPs. Select this
option if you can not get the IP address from your ISP even with a normal network
connection. This option is not required generally.
Click the button to active/terminate the connection.
WAN Configuration
Configuration Guide
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tl-r480t plus

Table of Contents