TP-Link TL-R470T Plus Configuration Manual page 132

Configuring Authentication
Figure 2-1 Configuring the Authentication Page
Follow these steps to configure authentication page:
1) In the Settings section, enable authentication status, configure the idle timeout and
portal authentication port.
Status
Idle Timeout
Portal
Authentication
Port
2) In the Authentication Parameters section, configure the parameters of the
authentication page.
Check the box to enable portal authentication.
Specify the idle timeout. The client will be disconnected after the specified
period (Idle Timeout) of inactivity, and is required to be authenticated again.
Value 0 means the client will always keep online until the authentication timeout
leased, even if the client remains inactive.
Enter the service port for portal authentication. The default setting is 8080.
Local Authentication Configuration
Configuration Guide 125