Grouping Ip Address Entries - TP-Link TL-R470T Plus Configuration Manual

Configuring Preferences
2.2

Grouping IP Address Entries

Choose the menu Preferences > IP Group > IP Group and click Add to load the following
page.
Figure 2-2 Create an IP Group
Follow these steps to create an IP group and add IP address entries to the group:
1) Specify a name and configure the range to add an IP address range.
Group Name
Address Name
Description
2) Click OK.
You can also choose an existing IP group and click
members.
Note:
An IP group that is being referenced by a rule cannot be deleted.
Enter a name for the IP group. Only letters, digits or underscores are allowed.
Select the IP address entries as the members of the group from the drop-down
list. It is multi-optional.
If no IP address entries are selected, the rule that references this IP group will
have no effect on any IP addresses.
(Optional) Enter an brief description of this IP group to make identifying it easier.
IP Group Configuration
to add or remove the IP address
Configuration Guide 49