TP-Link TL-R470T Plus Configuration Manual page 26

Configuring Network
 Configuring the BigPond Cable
Choose the menu Network > WAN > WAN to load the following page.
Figure 2-7 Configuring the BigPond Cable
In Connection Configuration section, select the connection type as BigPond Cable. Enter
the corresponding parameters and click Save.
Connection Type
Username
Password
Connection
Mode
Time
Upstream
Bandwidth
Downstream
Bandwidth
Choose the connection type as BigPond if your ISP provides you with a BigPond
account.
Enter the BigPond username provided by your ISP.
Enter the BigPond password provided by your ISP.
Choose the connection mode, including Connect Automatically, Connect Manually
and Time-Based.
Connect Automatically: The router will activate the connection automatically when
the router reboots or the connection is down.
Connect Manually: You can manually activate or terminate the connection.
Time-Based: During the specified period, the router will automatically activate the
connection.
Choose the effective time range when the Connection Mode is chosen as Time-
Based. To create the time range, go to Preferences > Time Range > Time Range.
Specify the upstream bandwidth of the WAN port. The value configured here is the
upper limit of the "Maximum Upstream Bandwidth" on Transmission > Bandwidth
Control > Bandwidth Control page, to make "Bandwidth Control" take effect, please
ensure this parameter is set correctly.
Specify the downstream bandwidth of the WAN port. The value configured here is the
lower limit of the "Maximum Downstream Bandwidth" on Transmission > Bandwidth
Control > Bandwidth Control page, to make "Bandwidth Control" take effect, please
ensure this parameter is set correctly.
WAN Configuration
Configuration Guide 19