TP-Link TL-R470T Plus Configuration Manual page 46

Configuring Network
Choose the menu Network > IPv6 > WAN to load the following page.
 Configuring the Dynamic IP (SLAAC/DHCPv6)
Figure 8-2 Configuring the Dynamic IP (SLAAC/DHCPv6)
Follow these steps to configure Dynamic IP connection:
1) In the General section, check the box to enable IPv6 function, then click Save.
IPv6
2) In the Internet section, choose the Internet Connection type as Dynamic IP (SLAAC/
DHCPv6), and configure the corresponding parameters. Then click Save.
Internet
Connection Type
IPv6 Address/
Primary DNS/
Secondary DNS
Renew
Release
Check the box to enable IPv6 function.
Choose Dynamic IP (SLAAC/DHCPv6) as the connection type.
Displays the IPv6 address/Primary DNS/Secondary DNS of the WAN port. These
parameters are automatically assigned by the DHCPv6 server from your ISP.
Click this button to get new IPv6 parameters assigned by the DHCPv6 server
from the ISP.
Click this button to release the IPv6 parameters assigned by DHCPv6 server
from the ISP.
IPv6 Configuration
Configuration Guide 39