D-Link DES-3250TG Command Line Interface Reference Manual page 285

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config access_profile
dst_port <value 0-65535> − Specifies that the
access profile will apply only to packets that
have this UDP destination port in their header.
protocol_id <value 0-255> − Specifies that the
switch will examine the Protocol field in each
packet and if this field contains the value
entered here, apply the following rules.
user_define <hex 0x0-0xfffffff> − Specifies a
mask to be combined with the value found in the
frame header using a logical AND operaiton.
priority <value 0-7> − Specifies that the access
profile will apply to packets that contain this
value in their 802.1p priority field of their header.
replace_priority − This parameter is specified if
you want to change the 802.1p user priority of a
packet that meets the specified criteria.
Otherwise, a packet will have its incoming
802.1p user priority re-written to its original
value before being transmitted from the switch.
replace_dscp <value 0-63> − Allows you to
specify a value to be written to the DSCP field of
an incoming packet that meets the criteria
specified in the first part of the command. This
value will over-write the value in the DSCP field
of the packet.
delete <value 1-255> − Specifies that the
access ID of a rule you want to delete.
Restrictions Only administrator-level users can issue this
command.
285