Using The Console Cli - D-Link DES-3250TG Command Line Interface Reference Manual

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
U
SING THE
The DES-3250TG supports a console management interface that
allows the user to connect to the switch's management agent via a
serial port and a terminal or a computer running a terminal emulation
program. The console can also be used over the network using the
TCP/IP Telnet protocol. The console program can be used to configure
the switch to use SNMP-based network management software over the
network.
This chapter describes how to use the console interface to access the
switch, change its settings, and monitor its operation.
Switch configuration settings are saved to non-volatile
RAM using save command. The current configuration
will then be retained in the switch's NV-RAM, and
reloaded when the switch is rebooted. If the switch is
rebooted without using the save command, the last
configuration saved to NV-RAM will be loaded.
Connecting to the Switch
The console interface is used by connecting the Switch to a VT100-
compatible terminal or a computer running an ordinary terminal
emulator program (e.g., the HyperTerminal program included with the
Windows operating system) using an RS-232C serial cable. Your
terminal parameters will need to be set to:
C
ONSOLE
17
2
CLI