D-Link DES-3250TG Command Line Interface Reference Manual page 184

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
show bandwidth_control
Purpose Used to display the bandwidth control
configuration on the switch.
Syntax
show bandwidth_control {<portlist>}
Description The show bandwidth_control command displays
the current bandwidth control configuration on
the switch, on a port-by-port basis.
<portlist> − Specifies a range of ports to be
Parameters
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4 specifies all of the ports between port 3
and port 4 − in numerical order.
Restrictions None.
Example Usage:
To show bandwidth control for ports 1 through 11:
local>show bandwidth_control 1-11
Command: show bandwidth_control 1-11
Bandwidth Control Table
Port RX Rate (Mbit|sec)
---- ------------------------
1 no_limit
2 no_limit
3 no_limit
TX_RATE (Mbit|sec)
----------------------
10
10
10
184