D-Link DES-3250TG Command Line Interface Reference Manual page 178

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config traffic_segmentation
Purpose Used to configure traffic segmentation on the
switch.
Syntax config traffic_segmentation <portlist>
forward_list [null|<portlist>]
Description The config traffic_segmentation command is
used to configure traffic segmentation on the
switch.
<portlist> − Specifies a range of ports that will be
Parameters
configured for traffic segmentation. The port list
is specified by listing the beginning port number
and the highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4 specifies all
of the ports between port 3 and port 4 − in
numerical order.
forward_list − Specifies a range of ports that will
receive forwarded frames from the ports
specified in the portlist above.
null − Specifies that packets cannot be forwarded
to any ports.
<portlist> − Specifies a range of ports that will be
configured for traffic segmentation. The port list
is specified by listing the beginning port number
and the highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4 specifies all
of the ports between port 3 and port 4 − in
numerical order.
Restrictions Only administrator-level users can issue this
command.
178