D-Link DES-3250TG Command Line Interface Reference Manual page 130

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config syslog host
be sent to the remote host. This corresponds to
number 19 from the list above.
local4 − Specifies that local use 4 messages will
be sent to the remote host. This corresponds to
number 20 from the list above.
local5 − Specifies that local use 5 messages will
be sent to the remote host. This corresponds to
number 21 from the list above.
local6 − Specifies that local use 6 messages will
be sent to the remote host. This corresponds to
number 22 from the list above.
local7 − Specifies that local use 7 messages will
be sent to the remote host. This corresponds to
number 23 from the list above.
udp_port <udp_port_number> − Specifies the
UDP port number that the syslog protocol will
use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address
of the remote host where syslog messages will
be sent.
state [enabled|disabled] − Allows the sending of
syslog messages to the remote host, specified
above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this
command.
130