D-Link DES-3250TG Command Line Interface Reference Manual page 260

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config 802.1x init
Purpose Used to initialize the 802.1x functions on a
range of ports.
Syntax
config 802.1x init port_based ports
[<portlist>|all]|mac_based ports
[<portlist>|all]| {mac_address <macaddr>}
Description The config 802.1x init command is used to
immediately initialize the 802.1x functions on a
range of ports.
port_based|mac_based ports − The switch
Parameters
allows you to configure 802.1x by either port or
MAC address.
<portlist> − Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port
4 − in numerical order.
all − Specifies all of the ports on the switch.
Restrictions Only administrator-level users can issue this
command.
260