System Components; Power On - Zeiss Humphrey II-i series User Manual

System Components

Chin rest control
Patient response button
Patient button connection

Power On

The power switch is located on the rear panel of the instrument
be dimmed or off when turning on the HFA II-
performing a self-diagnostic checkup. In the event that the internal computer detects a problem, a
message will appear on the start-up screen. Call Carl Zeiss Meditec Customer Service, if necessary.
Should you need to unplug any component from the HFA II-
the HFA II-
Whenever there is a question as to whether the HFA II-
question about electrical or fire safety: TURN OFF AND UNPLUG THE INSTRUMENT and call Carl
Zeiss Meditec customer care as soon as possible: 1-800-341-6968. Outside the U.S., contact your
local Carl Zeiss Meditec distributor.
Humphrey Field Analyzer II-
Introduction & Instrument Setup
Figure 1.4 The HFA II-i – Side View
i
. Disconnection procedures are the opposite of the sequence listed in this section.
i series User Manual
(Figure 1.5). The room lights should
i . Once it is powered up, the HFA II-
i , remember to first turn off the power to
i
is running properly or if there is any
2660021145640 A
1-23
Touch screen
Touch screen
brightness
control
Hard drive
USB ports
i begins