Ce-100T-8 Loopback, J1 Path Trace, And Sonet Alarms - Cisco CE-100T-8 Operation

CE-100T-8 SONET Circuits and Features
The CE-100T-8 card supports GFP-F null mode. GFP-F CMFs are counted and discarded.
The CE-100T-8 card is interoperable with the ML-100T-8 card and several other ONS Ethernet cards.
For specific details on ONS Ethernet card interoperability, refer to the "POS on ONS Ethernet Cards"
chapter of the Ethernet Card Guide Software Feature and Configuration Guide—for the ONS 15454,
ONS 15454 SDH and ONS 15327.

CE-100T-8 Loopback, J1 Path Trace, and SONET Alarms

The CE-100T-8 card supports terminal and facility loopbacks when in the Out of Service, Maintenance
state (OOS, MT). It also reports SONET alarms and transmits and monitors the J1 Path Trace byte in the
same manner as OC-N cards. Support for path termination functions includes:
•
•
•
•
•
•
•
•
•
•
Cisco ONS 15310-CL Ethernet Card Software Feature and Configuration Guide, R5.0
16-10
H1 and H2 concatenation indication
C2 signal label
Bit interleaved parity 3 (BIP-3) generation
G1 path status indication
C2 path signal label read/write
Path level alarms and conditions, including loss of pointer, unequipped, payload mismatch, alarm
indication signal (AIS) detection, and remote defect indication (RDI)
J1 path trace for high order paths
J2 path trace for low order paths
J2 path trace for low order VCAT circuits at the member level
Extended signal label for the low order paths
Chapter 16 CE-100T-8 Ethernet Operation
June 2005