Answering Calls - Yealink SIP VP-T49G User Manual

The SIP VP-T49G IP phone can handle multiple calls at a time. However, only one active call (the
call that has audio associated with it) can be in progress at any time. The SIP VP-T49G IP phone
can handle a maximum of 50 calls at one time.
To place multiple calls:
You can have more than one call on your SIP VP-T49G IP phone. To place a new call during an
active call, do one of the following:
Tap the line key. The active call is placed on hold.
-
Enter the desired number.
Press
- Press
Tap the NewCall soft key.
Enter the desired number using the keypad or the dial pad.
Press
You can tap the desired call, and then tap the Resume soft key to retrieve it.
Note If multiple accounts are registered on the phone, you can first tap the desired line key on the idle
screen or tap the desired line from the status bar in dialing screen, and then you can use the
selected account to place a call.

Answering Calls

When you are not in another call, you can answer a call in one of three ways:
Using the handset

Using the speakerphone

Using the headset

Note You can reject incoming calls by tapping the Reject soft key to stop the phone from playing ring
tone. You can also activate the Do Not Disturb mode to reject the incoming calls without ringing
on your phone. For more information, refer to
You can forward incoming calls to someone else by tapping
information, refer to
Answering When Not in Another Call
Call duration and destination will always appear on the touch screen for the active call.
To answer a call using the handset:
Pick up the handset.
1.
or tap Send.
or tap the Hold soft key to place the original call on hold.
or tap Send.
Call Forward on page
Do Not Disturb (DND)
the FWD soft key
197
.
Basic Phone Features
on page 192.
. For more
163