Yealink SIP VP-T49G User Manual page 51

To configure the IP mode via phone user interface:
Tap ->Advanced (default password: admin) ->Network->WAN Port.
1.
Tap the IP Mode field.
2.
Tap the desired value (IPv4, IPv6 or IPv4 & IPv6) in the pop-up dialog box.
3.
Tap the Save soft key to accept the change or
4.
You can configure a static IPv4 address for the IP phone. Before configuring it, make sure
that the IP mode is configured as IPv4 or IPv4 & IPv6.
To configure a static IPv4 address via phone user interface:
Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv4.
1.
Tap the Type field.
2.
Tap Static IP in the pop-up dialog box.
3.
Enter the desired value in the IP, Subnet Mask, Gateway, Primary DNS and Secondary
4.
DNS field respectively.
Tap the Save soft key to accept the change or
5.
Getting Started
to cancel.
to cancel.
51