Call Waiting - Yealink SIP VP-T49G User Manual

User Guide for SIP VP-T49G IP Phone
desired contact to dial out. (Remote phone book should be configured in advance,
refer to
Tap History, and then tap the desired list. Tap the desired entry to dial out.
-
After the party answers the call, press
3.
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.

Call Waiting

You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call when there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
Tap ->Features->Call Waiting.
1.
Tap the On radio box in the Call Waiting field.
2.
Tap the On radio box in the Play Tone field.
3.
(Optional.) Enter the call waiting on code or off code respectively in the On Code or Off
4.
Code field.
If on code or off code is configured, the IP phone will send the corresponding code to
activate or deactivate call waiting on the server. They may vary on different servers.
Tap the Save soft key to accept the change or
5.
Call waiting is configurable via web user interface at the path Features->General Information.
210
Remote Phone Book on page 107 for more information.)
or tap Transfer soft key to complete the
to cancel.