Eaton Powerware 5125 Installation Manual page 18

For ibm applications

Hide thumbs Also See for Powerware 5125:

Table of Contents

INSTALLATION

13. For each optional EBM, loosen the wing nut on the rear hold-down

14. Tighten the pan-head screws that secure both rails to the front of

15. Continue to the following section, "Installing the Internal Batteries."

EATON Powerware

bracket and slide the EBM rear hold-down bracket into the slots on

the EBM rear panel.

Verify that the rear hold-down bracket is fully seated and then

tighten the wing nut.

Figure 9. Securing the Back of the EBM

the rack (see Step 3 on page 6).

5125 (9910-E65) UPS Installation Guide for IBM

Wing Nut on Rear

Hold-Down Bracket

(attached to rail)

Rear Hold-Down Bracket

(for EBM)

Applications

164201698 Rev 1

Table of Contents