Table of Contents
Advertisement
1.
MOUNTING
1.1
Installation of Multi Function Display
The TZT9F is designed to be mounted in a console or panel, or mounted on a desktop.
The installer of this equipment must read and follow the descriptions in this manual.
Wrong installation or maintenance can void the warranty.
Mounting considerations
When selecting a mounting location for your TZT9F, keep the following in mind:
• The temperature at the mounting location shall be between -15°C and +55°C.
• The humidity at the mounting location shall be 93% or less at 40°C.
• Locate the unit away from exhaust pipes and ventilators.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal (compliant with IEC 60945
Ed.4).
• Keep the unit away from electromagnetic field generating equipment such as
motors and generators.
• For maintenance and checking purposes, leave sufficient space around the unit and
leave slack in cables. Minimum recommended space is shown in the outline
drawing for the display units.
• Do not mount the unit on an overhead beam/bulkhead.
• A magnetic compass will be affected if the equipment is placed too close to it.
Observe the compass safe distances shown in the SAFETY INSTRUCTIONS to
prevent disturbance to the magnetic compass.
• You can install multiple TZtouch3 units side-by-side when flush mounting. Keep a
minimum of 29 mm between each cutout for access to fixtures and wing-bolts.
1-1
Advertisement
Table of Contents
