Batco 2035 Assembly Manual page 93

PORTABLE GRAIN BELT CONVEYOR – STANDARD
9. Bolt the lower ladder brace (4), the transport brace (14), and the ladder cross tube (13) to the ladder arms
(10) using bolts (20) and nuts (26), and u-bolts (31) and nuts (28). Do not tighten.
10. Bolt the ladder arms (10) to the lift arms (9) using two bolts (19), flat washer (38), and locknut (29).
11. Tighten u-bolts (31) on upper lift arm brace (12) starting with the bottom locknuts (28). While tightening,
ensure upper lift arm brace (12) is butted up against the tab stops on the lift arms (9). Tighten the remaining
u-bolts and repeat procedure for the lower lift arm brace (11).
12. Using a lifting device (crane and strong sling, or front-end loader with chain, or block & tackle system), raise
the discharge end of the conveyor at point A shown in
undercarriage.
13. Position scissor frame into position under tube assembly.
14. Lower the tube assembly onto the frame and align frame with suspension bracket as shown in
15. Connect the ladder arm (10) to the suspension bracket with bolts (19, 18), bushings (1), flat washers (34,
30), and nuts (31, 28) as shown in
16. Raise the tube at point A so the discharge end is approximately 10' off the ground. Attach a hoist at point B
on the scissor frame, and lift until the axle arms are aligned with the suspension bracket. Attach with bolts
(19, 18), bushings (1), flat washers (34, 30), and locknuts (31, 28).
17. Remove lifting device B.
18. Lift the tube at point A until the hydraulic rams (38, 34) can be positioned. Insert the ram pins and secure
them with snap pins.
Note
The hydraulic rams must be pointing down for the hoses to fit, with the hose connections pointing
to the outside.
19. Tighten crossbrace bolts (25, 28).
20. Lower tubes until the transport brace (14) rests on the lower lift arm brace (11).
21. Remove lifting device A.
Table 35. Scissor Lift Components
Item Description
1
Frame Bushing
2 Cross Brace 15
3 Axle Extendable
4 Lower Ladder Brace
5
Axle Arm
Axle Arm Lower Lh
6
Axle Arm Lower Rh
7
Axle Arm CrossBrace Long
8 Axle Arm CrossBrace Short
9
Lift Arm
10
Ladder Arm
P1512021 R6
Figure
Figure 63.
62. Height should be sufficient to clear the
Quantity
65'/75'
4
2
1
1
2
-
-
-
-
2
2
4. ASSEMBLY
Figure 62
85'/95'
4
4
1
1
-
1
1
1
1
2
2
93