Batco 2035 Assembly Manual page 52

4. ASSEMBLY PORTABLE GRAIN BELT CONVEYOR – STANDARD
Figure 24. Threading the First Cable (A)
Thread the Second Cable (B)
1. Thread the second cable (B) through the cable return located under cable bridge closest to the spout.
2. Pull the cable through the cable return until there is an equal amount of cable on either side.
3. Working towards the hopper end, thread both ends of the cable through the inner most cable clamps of the
cable bridge(s) all the way to the anchor bracket.
4. Verify there is an equal amount of cable on either side of the conveyor.
Figure 25. Threading the Second Cable (B)
Thread the Third Cable (C)
This procedure applies to 95' Models.
1. Thread the third cable (C) through the cable return located under cable bridge furthest from the spout end.
52 P1512021 R6