Batco 2035 Assembly Manual page 69

PORTABLE GRAIN BELT CONVEYOR – STANDARD
Thread the Conveyor Belt
1. From the spout end, pull the fish tape until the belt emerges from the spout.
Figure 40. Conveyor Belt Pulled Through the Spout
2. Wrap the belt around the spout roller and pull it back under the conveyor tube up to the s-drive.
3. Remove the s-drive bottom guard.
4. Loosen the s-drive pinch roller bolts and take-up roller bolts (on both sides of s-drive) to the end of their
threads.
Note
Do not tighten the nuts on the pinch roller bolts and take-up roller bolts on the s-drive until the belt
is fully installed.
5. Guide the belt through the s-drive as shown in the figure below.
6. Pull the conveyor belt out from the back of the s-drive until approximately 6' (1.8 m) of excess belt remains
on the stand behind the hopper.
Figure 41. S-Drive Conveyor Belt Path
P1512021 R6
4. ASSEMBLY
69