Batco 2035 Assembly Manual page 61

PORTABLE GRAIN BELT CONVEYOR – STANDARD
2. Slide a 1/2" thimble (2) through the turnbuckle eyebolt.
3. Slide three 1/2" cable clamps (3) down one end of the cable.
4. Slide the end of cable over the thimble and through the eyebolt until there is 3' cable overlap.
5. Thread the end of the cable back through cable clamps.
6. Tighten the first cable clamp next to the thimble.
7. Tighten the second and third cable clamps with a 12" spacing.
8. Trim excess cable and apply tape to the loose end.
Note
Ensure the cable is pulled tight before securing the cables on the opposite side of the conveyor.
Table 19.
Item Description
1
Turnbuckle
2
1/2" Thimble
3
1/2" Cable Clamps
Figure 33. Securing the Cable to the Turnbuckle Eyebolts
P1512021 R6
4. ASSEMBLY
61