Table of Contents
Advertisement
Operation
Turning off the centrifuge
The centrifuge is turned off by switching the main
switch into the "0"position.
The main power switch should be turned off
after a complete centrifugation run. Without
motor deceleration, it takes much longer
until the rotor comes to a halt.
The centrifuge is equiped with a special
switch for balancing potential voltage dis-
crepancies in the power grid. After pressing
the mains switch the display therefore may
still flash up to 10 seconds.
The opening of the centrifuge lid is only
possible by means of „lid open"-key
while the centrifuge is switched on!
36
WEEE Compliance:
This product is required to comply with the European
Union`s Waste Electrical & Electronic Equipment
(WEEE) Directive 2002/96/EC. It is marked with the
following symbol:
®
Fisher Scientific
has contracted with recycling / dis-
posal companies in each EU Member State, and this
product should be disposed of or recycled through
them.
Further information on Fisher Scientific`s compliance
with these Directives, the recyclers in your country, and
information on Fisher Scientific
assist the detection (EU-standard on the limitation of
hazardous substances) of substances subject to the
RoHS Directive are available at
www.fishersci.com
®
products which may
Hide quick links:
Advertisement
Table of Contents
