Removing The Rotor; Audible Alarm; Turning The Centrifuge Off - Fisher Scientific accuSpin 1 Operating Instructions Manual

Removing the rotor

1. Open the centrifuge lid.
2. Remove the rotor cover.
3. Unscrew the clamping sleeve counterclockwise
using the socket wrench supplied with the instru-
ment until no resistance exists.
4. Grab the rotor with both hands and pull it perpen-
dicularly off the drive shaft carefully. Make sure not
to tilt it.
Grab rotor with both hands and pull
upwards perpendicularly .
When using an aerosol-tight bio-containment cover,
you may remove the respective rotor from the drive
shaft without opening the cover! You may then open
the rotor e.g. in a safety work bench and decontami-
nate it.

Audible alarm

Accompanying all error messages, a warning signal is
given out which only is silenced upon pressing any key.

Turning the centrifuge off

By switching the main switch into "0" position the cen-
trifuge is turned off.
The main power switch should be turned off
after a complete centrifugation run. Without
motor deceleration, it takes much more time
until the rotor comes to rest.
The centrifuge lid can only be opened automatically if
the centrifuge is turned on!
Operation
45