Installing and Connecting B5 Redundant Power Systems
Figure 2-8
1 STK-RPS-150CH8 shelf
2 STK-RPS-150PS power supply
Removing an Installed STK-RPS-150PS
To remove a power supply installed in an operating system, proceed as follows:
1.
Unplug the AC power cord of the power supply from the AC power source first, then from
the rear of the power supply .
2.
Loosen the captive screws securing the power supply until it is released from the chassis front
panel.
3.
Pull the power supply out and remove it from the chassis.
4.
Repeat steps 1 through 3 for each additional power supply you plan to remove.
2-14 Installation
STK-RPS-150PS Installation in an STK-RPS-150CH8 Shelf
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
Note: If you plan to remove and not replace an STK-RPS-150PS, immediately reinstall coverplates
over any empty power supply slots to prevent EMI leakage from the chassis.
3 Captive screws (2)
4 Chassis power supply slot