Removing An Installed Stk-Rps-150Ps; Stk-Rps-150Ps Installation In An Stk-Rps-150Ch8 Shelf - Enterasys A4H124-24FX Hardware Installation Manual

Figure 2-7

STK-RPS-150PS Installation in an STK-RPS-150CH8 Shelf

1 STK-RPS-150CH8 shelf
2 STK-RPS-150PS power supply

Removing an Installed STK-RPS-150PS

To remove a power supply installed in an operating system, proceed as follows:
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
1. Unplug the AC power cord of the power supply from the AC power source first, then from the
rear of the power supply.
2. Loosen the captive screws securing the power supply until it is released from the chassis front
panel.
3. Pull the power supply out and remove it from the chassis.
4. Repeat steps 1 through 3 for each additional power supply you plan to remove.
5. Optionally, reinstall coverplates over empty slots. Coverplates are not required.
Installing and Connecting a Redundant Power System
3 Captive screws (2)
4 Chassis power supply slot
Enterasys A4 Fast Ethernet Switch Hardware Installation Guide 2-13