Installing An Sfp/10G Transceiver (Shown With Lc Connector And Without Dust Cover) - Enterasys B5G124-24 Hardware Installation Manual

Connecting to the Network
To install an SFP/10G transceiver, refer to Figure
1. With an antistatic wrist strap attached to your wrist, remove the transceiver from its
packaging. If there is a protective dust cover in the transceiver connector, do not remove it at
this time.
2. Hold the transceiver so that the connector will seat properly.
3. Carefully align the transceiver with the port slot as shown in Figure
4. Push the transceiver into the port slot until it "clicks" and locks into place.
Figure 2-19
dust cover)
1 Release tab
2 Wire handle
3 Transceiver top side
2-28 Installation
Caution: Carefully follow the instructions in this manual to avoid damaging the SFP/10G and switch
equipment.
The SFP/10G and switch equipment are sensitive to static discharges. Use an antistatic wrist strap
and observe all static precautions during this procedure. Failure to do so could result in damage to
the SFP/10G and switch equipment. Always leave the SFP/10G in the antistatic bag or an
equivalent antistatic container when not installed.
Precaución: Siga las instrucciones del manual para no dañar el SFP/10G ni del aparato, puesto
que son muy sensible a las descargas de electricidad estática. Utilice la pulsera antiestática y tome
todas las precauciones necesarias durante este procedimiento. Si no lo hace, podría dañar el SFP/
10G o del aparato. Mientras no esté instalado, mantenga el SFP/10G en su bolsa antiestática o en
cualquier otro recipiente antiestático.
Installing an SFP/10G Transceiver (shown with LC connector and without
2‐19 and proceed as follows.
4 Edge connector (insertion side)
5 Port slot
6 Transceiver side view
2‐19.